3D Printed Parts for an Aircraft Restoration - An Update

I think it's about time to update on my project 3d printing "faux gun barrels" for the restoration on a Bell P39 Airacobra non-flying display.

A restored P-39 Airacobra

The P-39 Airacobra I'm helping restore.

There's been some progress since my previous post!

The black PETG I was waiting for arrived, and I printed the new barrels using black instead of the gray I used for a test fit. 

One of the finished barrels

I found the PEtG I used worked well, but it was a little "stringy", and the finish wasn't quite as good as PLA or ABS. But it's nothing that a little sanding can't fix. It also helps that the barrels will be buried inside the flash suppressors, so a lot of them won't be seen. 

One of the guns temporarily placed in its the suppressor

What's left now is a final sanding to knock of the layer lines and a weathering to make the barrels look a little more weathered. 

Overall, it's been a pretty good first attempt!