A 3D "Doodle" with Simulation in Fusion 360

A few days ago, an experienced engineer was explaining to us how changing the geometry of a component could affect the loads that it could have on how a part could handle the forces placed upon it.

Where the conversation started.
The representation of the mounting foot.

He explained that adding ribs to a mounting foot could greatly change how the mounting foot absorbed the loads, making for a more durable part. 

The modified part with ribs encompassing
the mounting hole.

So on this night I decided to build two parts pictured above,  and applied the same load of 1500 psi to them using Fusion 360.  I thought it would be a good exercise, and an opportunity to validate what I had learned.

The hole diameters and positions are the same, as well as the face bearing the load. 

After fixing the parts in the same place, I ran a simulation to see what would happen.

And the results of these quick tests was pretty interesting!

The ribbed foot had a much higher safety factor than the non-ribbed part.

The two parts next to each other.
The difference 

It was a nice exercise and validation of a concept.  And it was nice to have Fusion 360's simulation capabilities to be able to quickly test out an idea and quantify it.

Best part is now I have these parts for reference later!

It's just like a 3D note!

And finally, if you'd like to download the parts I created, you can find them here and here!