A Fusion 360 - Quick Tip on Showing Modeled Threads

It's sizing up to be a hectic week, but here's a really quick tip I discovered while creating some aircraft fluid fittings in Fusion 360.

A typical 37 degree flared fitting.

Did you know that while creating, or editing threads, you can change whether the thread representation is shown as a graphical representation, or as a modeled thread?

And you can toggle it off at will!

Showing the modeled thread location.  Right click (1), and check (2)!

Check it out, and give it a try!  When rendering models, this can make the difference between an average rendering, or a great one!

When you rendering without the threads displayed....

Not a bad rendering, but something is wrong.....

But now if you check that one simple box....

Now that's a big difference! 

Keep it in mind for a time that you need it!